سلام یه lumia 950 rm-1105 دارم فلش میکنم ارور زیر رو میده الان پروداکتش هم 059x0d5 هست که من جایی اینت پروداکت رو پیدا نکردم الان رو صفحه قرمز مونده هر فایلی میزنم قبول نمیکنه
Connect phone on selected interface...

Core : v2.29 , WP10x FlashEngine : v3.2

FFU : RM1105_1078.0053.10586.13169.12716.035044_retail_p rod_signed.ffu
Checking FFU file, wait...
FFU Revision ID : 2.0
FFU Model ID : Microsoft.MSM8992.P6218_ATT
FFU RootKeyHash : 0000000000000000000000000000000000000000
FFU ChipSectors : 35651584
FFU Header : 0x00140000
FFU Payload : 0xA6DE0000
FFU FastVerify : Ok

Waiting for phone...
Dead mode is selected , no phone in normal mode found
1. Press and hold "Volume Down"
2. Insert USB cable
3. Hold button until phone will be detected

Device catched in BOOT mode!
Collect Info...
=== Nokia Flash App info :
Protocol Version : 2.41
Protocol Implementation : 2.75
=== Phone Initial info :
Phone Model ID : Microsoft.MSM8992.P6218.1.0
=== eMMC info :
eMMC Vendor : Samsung
eMMC CID : 0015
eMMC Size : 29820 MiB
=== Security Initial info :
Security Status : 000001000000
Secure Boot : Disabled
Secure eFUSE: Disabled
JTAG : Enabled
RDC Key : Not Present (Retail)
UEFI SBoot : Disabled
SecHW Key : Not Exists
Device RootKey : 9CFA9ADB101CE41EC5E0B4BF586BCD37A4BA931F
=== Other info :
SD present : False

Full Check skipped , will be checked by ImageSignature


Battery Level : 24%
!!!!!!!!!!! Battery Level VERY LOW !!!!!!!!!!! Charge it first !!!!!!!!!!!

Connect phone on selected interface...

Core : v2.29 , WP10x FlashEngine : v3.2

FFU : RM1105_1078.0053.10586.13169.12716.035044_retail_p rod_signed.ffu
Checking FFU file, wait...
FFU Revision ID : 2.0
FFU Model ID : Microsoft.MSM8992.P6218_ATT
FFU RootKeyHash : 0000000000000000000000000000000000000000
FFU ChipSectors : 35651584
FFU Header : 0x00140000
FFU Payload : 0xA6DE0000
FFU FastVerify : Ok

Waiting for phone...
Dead mode is selected , no phone in normal mode found
1. Press and hold "Volume Down"
2. Insert USB cable
3. Hold button until phone will be detected

Device boot not done
Check Drivers, battery charge
Try again in Dead mode

Core : v2.29 , WP10x FlashEngine : v3.2

FFU : RM1105_1078.0053.10586.13169.12716.035044_retail_p rod_signed.ffu
Checking FFU file, wait...
FFU Revision ID : 2.0
FFU Model ID : Microsoft.MSM8992.P6218_ATT
FFU RootKeyHash : 0000000000000000000000000000000000000000
FFU ChipSectors : 35651584
FFU Header : 0x00140000
FFU Payload : 0xA6DE0000
FFU FastVerify : Ok

Waiting for phone...
Dead mode is selected , no phone in normal mode found
1. Press and hold "Volume Down"
2. Insert USB cable
3. Hold button until phone will be detected

Device catched in BOOT mode!
Collect Info...
=== Nokia Flash App info :
Protocol Version : 2.41
Protocol Implementation : 2.75
=== Phone Initial info :
Phone Model ID : Microsoft.MSM8992.P6218.1.0
=== eMMC info :
eMMC Vendor : Samsung
eMMC CID : 0015
eMMC Size : 29820 MiB
=== Security Initial info :
Security Status : 000001000000
Secure Boot : Disabled
Secure eFUSE: Disabled
JTAG : Enabled
RDC Key : Not Present (Retail)
UEFI SBoot : Disabled
SecHW Key : Not Exists
Device RootKey : 9CFA9ADB101CE41EC5E0B4BF586BCD37A4BA931F
=== Other info :
SD present : False

Full Check skipped , will be checked by ImageSignature


Battery Level : 29%
RPMB Provision Status Code : 0x0101
Device RAM size : 3072 MiB
Device have ATRP (AntiTheft) system!
Backup to RAM Ok!

FFU : RM1105_1078.0053.10586.13169.12716.035044_retail_p rod_signed.ffu
Flashing FFU
Sending FFU Header CertData
Header sent , accepted :)
Skip Data Partition Erase
Sending FFU Payload Data...
Finishing flashing
FFU sent sucessfully, but device can't finalize flashing! HW error or wrong FFUImage!
Red Light :(
Error during flashing!
LastErr : FFFFFFFFFFFFFFFF00000000
[Info] : Check previous message carefully , follow given advises
[Info] : Recommended to not power off device, if it shows "RED SCREEN"
[Info] : After problems will be fixed - tick "Recovery" and repeat flashing again!